C & G SECURITY ENGINEERING
DIY KIT INSTALL
GUIDE
Balustrade, Fence & Gate Kit Install guidance and options. Easy to install with simple steps and very universal for all different type of applications.
Bottom rail install option 1
Step 1
Step 2
Step 3
Top rail installation
Top rail has a bracket inside. When fixed into position simply drill a hole in the bracket then when level is achieved screw into the area where it needs to be attached. A handrail is then applied over the top and no mess is seen for a neat finish.
Step 4
Step 5
Step 1:
Place the section to the application to where it needs to be fixed to.
Step 2:
Mark where the L bracket needs to be attached and simply fasten to the application where the section needs to be secured. Screws or bolts will depend on the material of the application.
Step 3:
Make two cuts approximately 60mm to create an aluminium tab. Peel back the Aluminium tab. Simply cut the peeled back aluminium tab approximatley 5mm.
Step 4:
With the peeled back aluminium tab that has been cut 5mm and with the opening of the slot slip it over the L bracket and push down firmly into place.
Step 5:
Simply pull the aluminium tab upwards for a nice neat finish with no mess or screws seen.
Bottom rail install option 2
Simply cut the section to size where it needs to be fixed. Slip the sleeve over the bottom rail and fasten into the application to secure the section firmly. The top rail has a bracket inside. Secure the top bracket also and slip the handrail over the top for a neat and tidy finish.